Float setting
-
Eric
- Expert
- Posts: 2689
- Joined: Wed Sep 17, 2008 9:54 am
- Location: Bridgend
Float setting
Where can I find how to set the float heights on my H2c please.? I been on Dale`s sight and can find how to do it on the H1 but not the H2c.
-
Barrie
- Expert
- Posts: 867
- Joined: Thu May 04, 2006 12:52 pm
- Location: Queenborough Kent U.K.
Re: Float setting
I think you'll find it's the same method and the same height
-
Nigel S
- Expert
- Posts: 2123
- Joined: Wed Sep 17, 2008 9:54 am
- Location: Lowestoft
Re: Float setting
Check mraxl resource page I am sure its there somewhere.
Ever started something you wish you had'nt.
-
Nick64
- Expert
- Posts: 1057
- Joined: Thu May 04, 2006 12:52 pm
- Location: Ilford Essex
Re: Float setting
Carb specs here http://kawtriple.com/mraxl/carbspec.html
How to here http://www.3cyl.com/mraxl/manuals/carbt ... .htm#float height
How to here http://www.3cyl.com/mraxl/manuals/carbt ... .htm#float height
KH400A4
My Dad told me "If it's stuck use a bigger hammer."
My Dad told me "If it's stuck use a bigger hammer."
-
BIG H
- Expert
- Posts: 1059
- Joined: Thu May 04, 2006 12:52 pm
- Location: SITTINGBOURNE,KENT.
Re: Float setting
The best way to set float heights is to set the fuel level.
I do it by putting the carb in a jug,connecting a fuel supply to the carb.
The fuel should stop just under the carb body with a gap of between
2 & 4mm,as stated in the H series manual.(page 52)
I do it by putting the carb in a jug,connecting a fuel supply to the carb.
The fuel should stop just under the carb body with a gap of between
2 & 4mm,as stated in the H series manual.(page 52)
You do not have the required permissions to view the files attached to this post.