Kawasaki Triples Club

just received these two fork damper which are meant to be both part number 44022027 to fit my h1 but clearly they are different they are both the same size length and diameter I know there is a bushing/ piston missing but just wondering if I can accutually use the one on the left of the picture the box it came in had part number 44022019 any ideas ?

I don't know at all if you can use them in opposite legs of the same pair of forks but 44022-019 was the original H1B part number that was superceded
by 44022-027 which then ran all the way through the later 500's. That in part number terms usually means that they are a direct replacement,

Hi Simon
The one on the right (from Memory) looks the same as the H2C the one on the left looks the same as the KH 500.
If you can use them together or not I do not know. But I had a similar issue when I bought the H2C and I searched Ebay until I had a matching pair.

So if you are looking for one the same as the one on the left, I should have one. Will look when I get home and give you a call.

Cheers nigel that will be handy speek to you soon
Simon

gsxrtriple wrote:Cheers nigel that will be handy speek to you soon
Simon

well after leaving yours last night I pulled my other forks apart and this is what I found result
result

Nice one.

Then you have matching set at last.

Nigel S wrote:Nice one.

Then you have matching set at last.

yea will pop your damper back when your next home

Don't panic. I can take a trip over to greens for a couple of little jobs that I need him to do. Can call into yours on the way, see how you are getting on.