S3 side stand to fit H2
Posted: Sun Apr 19, 2015 7:55 am
Here's my modified S3 stand for the H2 ready for painting.
This is how much I had to build up and fine tune the detailing so that the stand swings up into place as far as it can but just clears the bottom of the silencers. It took about 20 fittings to get right. Every time I had to fit the spring and do the bolt up tight otherwise I couldn't tell where it was really going to end up.
This the cleaned up weld where I had to remake the extension bar as the S3 one was totally wrong to fit round the Higgspeed chambers.
This is how much I had to build up and fine tune the detailing so that the stand swings up into place as far as it can but just clears the bottom of the silencers. It took about 20 fittings to get right. Every time I had to fit the spring and do the bolt up tight otherwise I couldn't tell where it was really going to end up.
This the cleaned up weld where I had to remake the extension bar as the S3 one was totally wrong to fit round the Higgspeed chambers.
