1972 KH500
Posted: Wed Jul 08, 2015 6:52 pm
Page 1 of 1
Re: 1972 KH500
Posted: Wed Jul 08, 2015 7:49 pm
Deffo early H1 pipes, the pictures aren't that good but as the seller says "the photos tell all"
Re: 1972 KH500
Posted: Wed Jul 08, 2015 8:16 pm
JLomas had done a few set of pipes on 2 parts for later H1 years ago (at least one as I had seen a H1D with and had put a picture on the forum) is it one of these sets?
Re: 1972 KH500
Posted: Wed Jul 08, 2015 8:48 pm
I suppose it must be an H1D frame, if I was an H1B it would have to have had considerable frame modification to fit the later tank, seat and tail units. An H1D with early exhausts I would think. Nice alloy rims and twin discs 
Pete
Pete
Re: 1972 KH500
Posted: Thu Jul 09, 2015 5:01 pm
You can fit a later H1 tank onto a B frame with no frame mods! Just two lugs on the tank!
The tail hump can sit on brackets that push into the frame tubes where the grab rail goes. The seat fits straight on. The side panels are a bit trickier as one is an oil tank!
Heres my HIb from the 80s!
The tail hump can sit on brackets that push into the frame tubes where the grab rail goes. The seat fits straight on. The side panels are a bit trickier as one is an oil tank!
Heres my HIb from the 80s!
Re: 1972 KH500
Posted: Fri Jul 10, 2015 9:20 pm
Well I grafted a H2 tail section onto a H1a
http://i986.photobucket.com/albums/ae34 ... 6559372065
http://i986.photobucket.com/albums/ae34 ... 6559372065
Re: 1972 KH500
Posted: Sat Jul 11, 2015 4:06 pm
And it's a fabulous looking thinggary62 wrote:Well I grafted a H2 tail section onto a H1a
http://i986.photobucket.com/albums/ae34 ... 6559372065
Pete