Kawasaki Triples Club

anyone on the club site have access to rotary grinder to modify some crank pins for me ?
it cant be done on lathe as material too hard its not a huge amount its around 1mm off the outer section on each side to fit the pins into crank webs ,there was a guy local to me but hes had health problems so its difficult

gary 07779094462

I gotta 6" angle grinder and a big file if want to try that ??

naughty boy

downpipe3 wrote:anyone on the club site have access to rotary grinder to modify some crank pins for me ?
it cant be done on lathe as material too hard its not a huge amount its around 1mm off the outer section on each side to fit the pins into crank webs ,there was a guy local to me but hes had health problems so its difficult

gary 07779094462

Hi Gary
How many do you want doing and when .

Baz

PM Sent