Page 1 of 1
Float setting
Posted: Mon Sep 21, 2015 12:43 pm
by Eric
Where can I find how to set the float heights on my H2c please.? I been on Dale`s sight and can find how to do it on the H1 but not the H2c.
Re: Float setting
Posted: Mon Sep 21, 2015 4:04 pm
by Barrie
I think you'll find it's the same method and the same height
Re: Float setting
Posted: Mon Sep 21, 2015 5:06 pm
by Nigel S
Check mraxl resource page I am sure its there somewhere.
Re: Float setting
Posted: Mon Sep 21, 2015 7:28 pm
by Nick64
Re: Float setting
Posted: Tue Sep 22, 2015 6:30 pm
by BIG H
The best way to set float heights is to set the fuel level.
I do it by putting the carb in a jug,connecting a fuel supply to the carb.
The fuel should stop just under the carb body with a gap of between
2 & 4mm,as stated in the H series manual.(page 52)