Page 1 of 1
Machining
Posted: Thu Jul 07, 2016 9:34 am
by 666rog
Do any of you know / recommend an engineering company that will make a small batch of turned components. Thanks in advance folk.
_________________
This post does not appear on Face book.
Re: Machining
Posted: Thu Jul 07, 2016 4:12 pm
by petearis
I use C&M engineering in Stockport - happy to do anything (and chat all day!) - 0161 477 9197. Don't suppose Stockport is very handy for you though.
Pete
Re: Machining
Posted: Thu Jul 07, 2016 11:07 pm
by emptyoiltank
DP Manufacturing
Blea Tarn, Low Water Lane
Palgrave
Diss
Norfolk
IP22 1SW
UK
tel: 01379 651776
Ask for Matt.
Re: Machining
Posted: Fri Jul 08, 2016 8:48 am
by 666rog
Thanks guys, will check them all out.
Re: Machining
Posted: Fri Jul 08, 2016 8:47 pm
by baz
666rog wrote:Do any of you know / recommend an engineering company that will make a small batch of turned components. Thanks in advance folk.
_________________
This post does not appear on Face book.
Hi
I run an engineering company in Hull let me know what your after if I can I will .
Baz
Re: Machining
Posted: Fri Jul 08, 2016 11:04 pm
by 666rog
Ok baz, pm me your number mate.