Kawasaki Triples Club

I have been speaking to Uwe from Accent regarding the ignition plate for the H1, as you can see from my previous posting about it it would appear that the unit he is developing only fitsthe later models with the 2 piece cover, he has asked me what the differences are and if I can get him a backplate. My questions are for all you multi bike and crank men , firstly is the end of the crank the same on the H1B and the later models, and are the casings interchangeable from the Bt the later models or would you have to fit the alternator parts from the later model as well.

I am also looking to see if someone has a spare backplate a Mitsubushi AZ2010M that they could sell me so I can send it to Uwe, he asked me for one but mine is in use, I feel that if he modifies his unit to fit the earlier models as well this will benefit many owners as well , as I have one of his units on my GT750 and it runs faultlessly and only took 30 to fit and set up.

As no one seems to have a spare plate I would be grateful for any suggestions where to try and get one is there any other bikes that use the same plate I know the H1R uses it but I'm sure they won't be many of them lying about.

The H1 b plate is a contact breaker plate peculiar to that model.

That's why it will be so hard to get one I may need to send him mine when I take the bike off the road in the winter.

Hi
I have a knackered stator for late H1/KH500, if that helps.

Doc

Think I have a NOS h1b backplate assembly that you could BORROW if that suits ??

robh1f wrote:Think I have a NOS h1b backplate assembly that you could BORROW if that suits ??

Hello its to send to Uwe in Germany to develop an electronic unit so I will ask him how long he would require it for as it wouldnt be get used in the system , I am also going to offer to test his system for him on my bike, I will send him an email and let you know what he says , thanks for the offer.

OK I will dig it out to make sure its the correct part number

Thanks I have contacted Uwe in Germany and also I am going offshore this week so I will get back to you when I hear from him.

Cheers.

Just seen this post, have several S/ H H1 points plates, I'm pretty sure that the earlier H1 European points plates are the same

If you need one still let me know

Gary T

Hello yes I am looking for one The one that is on my bike is stamped AZ2010M if you have a spare one that you could sell me that would be great another member offered to lend me one but I would prefer to give one to Uwe for his development, I have emailed him again but I think he is on holiday , I would think that he could use the electronics from his later H1 plate and just make a new resin one to suit the earlier one , as his pick up, which replaces the points cam should be the same.

I'll have a look over the weekend

Gary T

Cheers