h2 ignition coil standoffs
Posted: Mon Feb 08, 2021 9:31 pm
The hexagonal mounting with the M6 stud on one side and the M5 on the other - does anyone know where you can get them from?
Page 1 of 1
Re: h2 ignition coil standoffs
Posted: Fri May 21, 2021 12:32 am
I ended up making my own. Found a guy on ebay selling M5x18 (original standoffs were 17mm) with 10mmA/F instead of the standard 8mm. I drilled and tapped one half to M6. They're 1mm longer than normal, but look much better than the scabby old ones.
Re: h2 ignition coil standoffs
Posted: Fri May 21, 2021 6:18 am
They look great
BUT, 1mm longer than normal
thats three points off the judging at the next rally 
BUT, 1mm longer than normal
thats three points off the judging at the next rally Re: h2 ignition coil standoffs
Posted: Fri May 21, 2021 9:20 am
Don't chuck out the old ones as the one you show will look fine once it is re-zinced.
Re: h2 ignition coil standoffs
Posted: Sat May 22, 2021 9:11 pm
I could not possibly use a non standard part on my builds
Re: h2 ignition coil standoffs
Posted: Sat May 22, 2021 9:24 pm
New cad plate would have cost a couple of quid.....or make up a small box load and get it done for a score... 