Kawasaki Triples Club

Bought these pipes from Japan for an s2,£400 including post and charges, well then, what they dont mention, is you will have to make your own rear brackets, remove the centre stand, expected, the two pipes on the right are good, but the crossover pipe to the left, exit, under the chain, is an afterthought, so much so, i have had to cut and reweld this pipe to get it right, also, but no matter how much you cut and weld, this pipe fowls the sidestand, the stand pushes the pipe when raised, the spring and stand, pushing the pipe into the other two, and most likely, in a short matter of time, the pipes will blow at the manifolds, and possibly develop holes where they are making contact, the only solution to this, is to remove the side stand, purchase a bolt on side stand and mount it just behind the original exhaust mounting bracket on the left, that way, the main and side stand mountings can be retained.
So,easy and simple to fit??? NO!!!

Cheap for a reason then!

its what I expected Tony

Hi Andrew who makes them and any link?

bonjour, they came from Webike, Japan

Have a set for H2 non crossed; they fit w/o central stand but it was written on the part description for the H2.