Page 1 of 1
Gudgeon Pin Puller
Posted: Thu Oct 23, 2025 7:09 pm
by Vernon Thornton
Hi All.
Can anybody recommend a good gudgeon pin puller for an H2 please ?
Note : Not a tool to push the gudgeon pin out ( away from you ) - A tool to pull the pin out ( towards you ) viz ..
https://www.amazon.com/Sports-Parts-Pis ... B003CJMNBU
Cheers,
Vernon Thornton.
Re: Gudgeon Pin Puller
Posted: Sun Oct 26, 2025 12:32 pm
by doodah
Re: Gudgeon Pin Puller
Posted: Sun Oct 26, 2025 2:45 pm
by Tartan Triple
Re: Gudgeon Pin Puller
Posted: Sun Oct 26, 2025 7:17 pm
by g6mow
Just seen on FB.
Re: Gudgeon Pin Puller
Posted: Wed Oct 29, 2025 2:56 pm
by Vernon Thornton
Thanks all for your responses
Re: Gudgeon Pin Puller
Posted: Wed Oct 29, 2025 7:01 pm
by Wolfie
A long Bolt (+ nut) and a long socket can do the job, although not if the Cylinder next door is fitted.
The Bolt Head should be small enough to fit through the Piston but not the pin, rounding the head off a bit will give more clearance too.
Bolt goes in from the far side, through the Pin then through the Socket and the Nut goes on the end (with a washer). As it is tightened it pulls the Pin into the Socket.
Re: Gudgeon Pin Puller
Posted: Thu Oct 30, 2025 2:58 pm
by Doctorpayday
Hi
As wolfing suggested, but use cylinder head bolt.
Doc
