Page 1 of 1
Who can I get to restore my pipes?
Posted: Tue Apr 13, 2010 10:49 am
by Clive
I have a set of pipes for an early H1 in average condition that I need to get restored, who can I get to do a nice job on them? any suggestions?
Posted: Tue Apr 13, 2010 12:58 pm
by Ståle
Get a set of repros from Thomas Schwabenland.
Posted: Tue Apr 13, 2010 1:03 pm
by husson73
restore pipes isn't the issue: the cost with rechrome is expensive and if you use the bike as you must do the pipes brake.
Posted: Tue Apr 13, 2010 7:57 pm
by Clive
ståle wrote:Get a set of repros from Thomas Schwabenland.
Are they any good?
Posted: Tue Apr 13, 2010 8:13 pm
by Ståle
I believe they are. Looks good too. 900 euros a set. He has both early types.
Posted: Tue Apr 13, 2010 8:24 pm
by Clive
They look nice, do you have any contact detail for him?
Posted: Tue Apr 13, 2010 8:27 pm
by Ståle
PM JP for Thomas' contact info.
Posted: Tue Apr 13, 2010 9:11 pm
by Clive
Could you pm me JP's contact info so I can pm him for Thomas's contact info. Thanks.
Posted: Tue Apr 13, 2010 9:35 pm
by robh1f
Clive if you go ahead and get a set can you post results back on the board as am looking to get a couple of sets!! Cheers Rob.
Posted: Tue Apr 13, 2010 9:39 pm
by Clive
Will do Rob...watch this space.
Posted: Tue Apr 13, 2010 9:47 pm
by Ståle
Clive wrote:Could you pm me JP's contact info so I can pm him for Thomas's contact info. Thanks.
Sorry, JP is husson73. He posted in this thread on page 1. PM husson 73
Posted: Tue Apr 13, 2010 9:58 pm
by Clive
Thanks I should have known that.
Posted: Wed Apr 14, 2010 10:03 am
by Keith500
hi, it cost me £600 to have my pipes done triple plated and the dents removed they were on me 70 h1 at stafford one of them he had to cut apart and reweld
Posted: Wed Apr 14, 2010 10:21 am
by husson73
Clive email sends
Posted: Wed Apr 14, 2010 10:47 am
by Clive
Thanks JP.
Posted: Wed Apr 14, 2010 10:48 am
by Clive
Keith500 wrote:hi, it cost me £600 to have my pipes done triple plated and the dents removed they were on me 70 h1 at stafford one of them he had to cut apart and reweld
Who did them for you?
Posted: Wed Apr 14, 2010 5:15 pm
by Clive
Thomas is sold out and is taking orders for another batch that will be manufactured towards the end of the year. I had hoped to get somthing sorted sooner.
Posted: Wed Apr 14, 2010 10:15 pm
by robh1f
Oh dear......whats the price gonna be then??? better think about that at gen election time!!!!!!!!!!...............joke?!
Posted: Thu Apr 15, 2010 8:13 am
by husson73
thunk it's time to order a set for me (just in case...)
Posted: Fri Apr 16, 2010 7:58 am
by scouse
have seen Thomas's pipes in the flesh
they are very nice
just seen this thread
otherwise I could have told you he had sold out
Gary T
