Page 1 of 1
Vapour Blasting
Posted: Sat Jan 21, 2012 8:04 pm
by Eric
Just had my carbs Vapour Blasted by a guy local to me who is a bike nut , heres the result
This is his web site
http://www.swanplantair.co.uk/cleaning.html
Here is a Honda engine that was there when I picked the carbs up
Posted: Sun Jan 22, 2012 8:28 am
by Olde Coney
good service available here also.....
http://www.higgspeed.com/
Posted: Sun Jan 22, 2012 11:11 am
by Eric
I am awhere of that Rog but sometimes it is more convenient for people to take they`re stuff locally, Higgys 250 miles away and the guy I used is 2 miles away and that may suit others as well down this way.
Posted: Sun Jan 22, 2012 3:20 pm
by BRN2DRL
YEAH CONEY
Posted: Sun Jan 22, 2012 3:43 pm
by Olde Coney
BRN2DRL wrote:YEAH CONEY
either of the recommendations on here would be a touch to far for you then ..eh
Better if you stick to your rattlesnake
http://www.drinksmixer.com/drink6305.html
Posted: Sun Jan 22, 2012 3:45 pm
by Olde Coney
Eric wrote:I am awhere of that Rog but sometimes it is more convenient for people to take they`re stuff locally, Higgys 250 miles away and the guy I used is 2 miles away and that may suit others as well down this way.
Yep fair point Eric...I didn't know where you were located 
Posted: Sun Jan 22, 2012 9:45 pm
by stevie747
Make sure all the 'media' is rinsed out, I don't think I've ever had any vapour blasting done when any dead-end isn't full of shite
Except when Higgsy did my H2 carbs, that is
Posted: Mon Jan 23, 2012 7:22 am
by Eric
Thanks for the info but he has done that, I think he put it in the ultasonic cleaner and I checked when I had them back.
