grind

[downpipe3]

anyone on the club site have access to rotary grinder to modify some crank pins for me ?
it cant be done on lathe as material too hard its not a huge amount its around 1mm off the outer section on each side to fit the pins into crank webs ,there was a guy local to me but hes had health problems so its difficult

gary 07779094462

[Nigel S]

I gotta 6" angle grinder and a big file if want to try that ??

[downpipe3]

naughty boy

[baz]

anyone on the club site have access to rotary grinder to modify some crank pins for me ?
it cant be done on lathe as material too hard its not a huge amount its around 1mm off the outer section on each side to fit the pins into crank webs ,there was a guy local to me but hes had health problems so its difficult

gary 07779094462

Hi Gary
How many do you want doing and when .

Baz

[Klawsuc]

PM Sent