h2 ignition coil standoffs
-
doodah
- Expert
- Posts: 271
- Joined: Mon Oct 16, 2017 2:59 pm
- Location: West Sussex
h2 ignition coil standoffs
The hexagonal mounting with the M6 stud on one side and the M5 on the other - does anyone know where you can get them from?
-
doodah
- Expert
- Posts: 271
- Joined: Mon Oct 16, 2017 2:59 pm
- Location: West Sussex
Re: h2 ignition coil standoffs
I ended up making my own. Found a guy on ebay selling M5x18 (original standoffs were 17mm) with 10mmA/F instead of the standard 8mm. I drilled and tapped one half to M6. They're 1mm longer than normal, but look much better than the scabby old ones.
You do not have the required permissions to view the files attached to this post.
-
malc87
- Expert
- Posts: 13337
- Joined: Wed May 03, 2006 8:05 pm
- Location: Timperley,South Manchester
Re: h2 ignition coil standoffs
They look great
BUT, 1mm longer than normal
thats three points off the judging at the next rally 
BUT, 1mm longer than normal
thats three points off the judging at the next rally -
Hal
- Expert
- Posts: 2230
- Joined: Fri Dec 15, 2006 10:33 am
- Location: Surrey
Re: h2 ignition coil standoffs
Don't chuck out the old ones as the one you show will look fine once it is re-zinced.
-
SAM
- Expert
- Posts: 9426
- Joined: Wed May 03, 2006 8:05 pm
- Location: BIG SHED IN A NICE VILLAGE WITH A GOOD LOCAL. BEDFORDSHIRE
Re: h2 ignition coil standoffs
I could not possibly use a non standard part on my builds
THREES MORE FUN
-
robh1f
- Expert
- Posts: 3030
- Joined: Wed May 03, 2006 8:05 pm
- Location: Essex Coast
Re: h2 ignition coil standoffs
New cad plate would have cost a couple of quid.....or make up a small box load and get it done for a score... 