H1 motor rebuild

johnnymoped · Post by **johnnymoped** » Fri Oct 07, 2011 6:11 pm

Hi, is there anyone on here or who is recomended for an H1 motor strip, check and re-build? Any idea of cost assuming seals and bearings need replacing along with a rebore, pistons etc?
Thanks.

malc87 · Post by **malc87** » Fri Oct 07, 2011 7:55 pm

Dave Higgs of Higgspeed exhaust fame has just stripped and rebuilt two H2 motors for me.
As a bonus he has a vapour blaster on site..
Did a top quality job at a good price.
Very highly recommended.
I supplied the gasket and seal kits to Dave.

Hal · Post by **Hal** » Sat Oct 08, 2011 7:54 am

You're in Derbyshire so Nottingham is close by. Try calling RB's and Alan Smith/Kev Melling who do much of his work now can take care of it. Possibly they can pick it up as a whole bike as they run around a fair bit too, then they can ensure it is set up and running correctly as well before you have it back. You won't be dissatisfied.

I can PM you various tel numbers if you don't have them?

Neil the Don · Post by **Neil the Don** » Wed Oct 12, 2011 12:32 pm

Strip , inspect & rebuild. Labour £ 250.

Vapour blast all casings and top end. £ 140

New seals & gaskets all round £ 70

Crank rebuild with new rods £ 356 ( or just brgs & seals £ 220 )

Rebore £45 for 3 cylinders. Pistons ; Wiseco / Wossner or
Jap cheapies ?

Thats about right , eh ?

SAM · Post by **SAM** » Wed Oct 12, 2011 12:57 pm

Sounds good Neil. You should consider a Career in doing this?

Neil the Don · Post by **Neil the Don** » Wed Oct 12, 2011 5:21 pm

Yeah Sam !!

I could call it something like " Triples Workshop" ?

Oh , hang on...........

johnnymoped · Post by **johnnymoped** » Thu Oct 13, 2011 11:06 pm

Thanks for the advice so far - greatly appreciated.
When I collect my H1 I can decide where it goes

GinaG · Post by **GinaG** » Fri Oct 14, 2011 7:42 pm

Johnnymoped wrote:Thanks for the advice so far - greatly appreciated.
When I collect my H1 I can decide where it goes

Why not save your self the expense now & just ride it over Beachie Head & have done with it

When I get me moped screaming with spunk I'm gonna ride , ride , ride! eeee up Jasper Carrot

long ago, outside a chip shop in Walthamstow, stood a young geezer called greezy joe, jumped on his moped & said lets go!

He was keen, off up the high St like Barry sheene, till he met Sue on her new machine!! Froooming away together Froooming away in leather, Ann & Joe.

They passed the bloody tower at 100 mph, & they were so amazed the tower bridge was raised, they raced off to the top but found they could'nt stop, they flew right off the end & landed in the Thames, Hand in Hand!!

Good Luck Donald Duck

robh1f · Post by **robh1f** » Fri Oct 14, 2011 9:41 pm

Del send me some of those pills you MUST be taking PLEASE

johnnymoped · Post by **johnnymoped** » Sat Oct 15, 2011 10:17 am

delboy wrote:
Johnnymoped wrote:Thanks for the advice so far - greatly appreciated.
When I collect my H1 I can decide where it goes
Why not save your self the expense now & just ride it over Beachie Head & have done with it

When I get me moped screaming with spunk I'm gonna ride , ride , ride! eeee up Jasper Carrot

long ago, outside a chip shop in Walthamstow, stood a young geezer called greezy joe, jumped on his moped & said lets go!

He was keen, off up the high St like Barry sheene, till he met Sue on her new machine!! Froooming away together Froooming away in leather, Ann & Joe.

They passed the bloody tower at 100 mph, & they were so amazed the tower bridge was raised, they raced off to the top but found they could'nt stop, they flew right off the end & landed in the Thames, Hand in Hand!!

Good Luck Donald Duck

Goodness you are ODD

mal71 · Post by **mal71** » Sat Oct 15, 2011 7:29 pm

You know him then

johnnymoped · Post by **johnnymoped** » Sat Oct 15, 2011 8:25 pm

mal71 wrote:You know him then

Not yet -

Tomorrow I put pictures of my H1 up -

Post by **Wolfie** » Sun Oct 16, 2011 6:51 pm

Johnnymoped wrote:Tomorrow I put pictures of my H1 up -

That'll make yer eyes water..

johnnymoped · Post by **johnnymoped** » Sun Oct 16, 2011 7:40 pm

Here you go!

H1D masquerading as an 'E or F'

Looks like it has had some kind of infestation at some

husson73 · Post by **husson73** » Mon Oct 17, 2011 9:12 am

change the air filter

johnnymoped · Post by **johnnymoped** » Mon Oct 17, 2011 7:28 pm

Why

I think it will be OK with a clean up

Gary557 · Post by **Gary557** » Mon Oct 17, 2011 8:05 pm

Where are you in Derbyshire? I am in Chesterfield and might be able to help !!

Gary

Kawasaki Triples Club

H1 motor rebuild

H1 motor rebuild

Thanks.

Re: Thanks.

Re: Thanks.