Vapour Blasting

Eric · Post by **Eric** » Sat Jan 21, 2012 8:04 pm

Just had my carbs Vapour Blasted by a guy local to me who is a bike nut , heres the result

This is his web site http://www.swanplantair.co.uk/cleaning.html
Here is a Honda engine that was there when I picked the carbs up

Olde Coney · Post by **Olde Coney** » Sun Jan 22, 2012 8:28 am

good service available here also.....

http://www.higgspeed.com/

Eric · Post by **Eric** » Sun Jan 22, 2012 11:11 am

I am awhere of that Rog but sometimes it is more convenient for people to take they`re stuff locally, Higgys 250 miles away and the guy I used is 2 miles away and that may suit others as well down this way.

BRN2DRL · Post by **BRN2DRL** » Sun Jan 22, 2012 3:20 pm

YEAH CONEY

Olde Coney · Post by **Olde Coney** » Sun Jan 22, 2012 3:43 pm

BRN2DRL wrote:YEAH CONEY

either of the recommendations on here would be a touch to far for you then ..eh

Better if you stick to your rattlesnake

http://www.drinksmixer.com/drink6305.html

Olde Coney · Post by **Olde Coney** » Sun Jan 22, 2012 3:45 pm

Eric wrote:I am awhere of that Rog but sometimes it is more convenient for people to take they`re stuff locally, Higgys 250 miles away and the guy I used is 2 miles away and that may suit others as well down this way.

Yep fair point Eric...I didn't know where you were located

stevie747 · Post by **stevie747** » Sun Jan 22, 2012 9:45 pm

Make sure all the 'media' is rinsed out, I don't think I've ever had any vapour blasting done when any dead-end isn't full of shite

Except when Higgsy did my H2 carbs, that is

Eric · Post by **Eric** » Mon Jan 23, 2012 7:22 am

Thanks for the info but he has done that, I think he put it in the ultasonic cleaner and I checked when I had them back.