Stand for H2?

[Bic_Bicknell]

I've just taken delivery of a lovely set of stainless expansion chambers from Higgspeed and will have to remove the centerstand.

What are the recommendations for the best stand for a triple? I have a few different stands but, (after 20 years of sports bikes), they are all specifically for bikes with race bobbins on, or near, the rear axle. I also use an ABBA stand now on my Superduke which is the best stand ever but it used the swing arm pivot to support the bike in the center and I don't see a way of using this on the Kwak.

Even my older stands, that I no longer have, had adaptors which went under the rear of the swing arm but these were for a large box section swing arm, not a small round tubular one.

Thanks for any advice.

[Vince2]

As you've got rid of your main stand, I guess you'll use the side stand more.
Best tip I had was that the 250 side stand will fit the H2b/c and is about an inch longer. Makes it much more secure with not so much lean over.
.

[h2bchris]

I use a paddock stand under my box section swinging arm , it will not be so easy for you with the std rounded profile swinging arm though, but maybe worth a try !

[nipper]

I use these for the Garage http://www.ebay.co.uk/itm/Motorcycle-Su ... 5d44659a4e

[Peter Mac]

Do they work on a stock 19 inch wheel nipper as I was gonna buy one a while back & description states up to 18 inch ?