master cylinder problem

nogger · Post by **nogger** » Thu Feb 26, 2009 12:50 pm

Apart from the rubber dust cover are there any more rubber or plastic plastic parts on the assembly, finding difficult to get the cir-clip off down the end so I can pull the piston out. As the lad who powder coated everything for me made such good job of masking up I was going to let him powder coat this also. Whatya think ?

the180kid · Post by **the180kid** » Thu Feb 26, 2009 4:41 pm

you need to get that clip out, superb job powder coated, do all mine that way,

with silicone brake fluid, afore anyone chips up,.

dont get any in the bowl or on the threads, mask it up well..

nogger · Post by **nogger** » Sat Feb 28, 2009 1:15 pm

Thanks for the tip Blackpool

I managed to get the clip out but I had to take the grinder to my circlip pliers to get them down the hole it's a bit tight EH? so every thing is out OK. I'm off to powder coaters, I'm also going to get my speedo cases done as he can do a wrinkle finish

the180kid · Post by **the180kid** » Sat Feb 28, 2009 1:53 pm

nogger wrote:Thanks for the tip Blackpool I managed to get the clip out but I had to take the grinder to my circlip pliers to get them down the hole it's a bit tight EH?

me too,.... :smt023

Keith500 · Post by **Keith500** » Sat Feb 28, 2009 2:11 pm

would not mind seeing a pic of the wrinkle finish when you have got them done
thanks keith

nogger · Post by **nogger** » Sat Feb 28, 2009 4:53 pm

yeh Keith, will post pic of result.