Front forks
Posted: Sat Apr 06, 2024 11:13 pm
Hi all , anyone got the special tool for holding fork internal while tightening the Allen bolt. Any chance I could borrow it please.
Cheers Mike
Cheers Mike
Page 1 of 1
Re: Front forks
Posted: Sat Apr 06, 2024 11:47 pm
Re: Front forks
Posted: Sun Apr 07, 2024 7:37 am
Cheers Tony. I will make one to your specifications.
Re: Front forks
Posted: Sun Apr 07, 2024 8:29 am
Hi again Tony. As I have the forks and dampers fitted to save me taking one out. Can you give me an internal measurement of the squashed sides please.
Cheers Mike
Cheers Mike
Re: Front forks
Posted: Sun Apr 07, 2024 10:12 am
Re: Front forks
Posted: Sun Apr 07, 2024 10:53 am
Cheers Tony, I’ll get one from Halfords on way home from visiting mum in hospital.
Cheers Mike
Cheers Mike
Re: Front forks
Posted: Sun Apr 07, 2024 7:07 pm
Halfords is too good, a cheap chinese socket is what you need 
Re: Front forks
Posted: Sun Apr 21, 2024 2:22 pm
Hi Tony , as you say the Halfords socket was too good to destroy, I put it in my tool chest for save keeping.
Popped along to my local car boot today and purchased two 14mm sockets to butcher and squash and
a 12mm socket to make into a claw. 50p each both look cheap and Chinese made.
All the best Mike
, as you say the Halfords socket was too good to destroy, I put it in my tool chest for save keeping. Popped along to my local car boot today and purchased two 14mm sockets to butcher and squash and
a 12mm socket to make into a claw. 50p each both look cheap and Chinese made.
All the best Mike
Re: Front forks
Posted: Mon Apr 22, 2024 9:16 am
Nice one
Re: Front forks
Posted: Sun May 05, 2024 12:07 am
Hi Tony , It worked !!!!!forks are now fitted to frame. It’s coming on slowly.
Thanks again for your help. Mike
Thanks again for your help. Mike
Re: Front forks
Posted: Sun May 05, 2024 10:21 am
