Page 1 of 1
Danish E Bay. NOS H1 Rear "Fender"
Posted: Wed Aug 25, 2010 9:52 am
by Neil the Don
Jeez. Have you seen this one ? Bloke in Denmark selling off some NOS stuff. 2 days left and currently at £451. Strangely , I can`t see that its drilled at all. Looks just like the one`s I have had made that ........... Have to put my prices up !!!
Posted: Wed Aug 25, 2010 11:20 am
by Richard S
Posted: Wed Aug 25, 2010 1:44 pm
by SAM
Better think about selling my kh500 one?
Posted: Wed Aug 25, 2010 2:00 pm
by husson73
but your isn't NOS?
Posted: Wed Aug 25, 2010 3:20 pm
by SAM
husson73 wrote:but your isn't NOS?
True 
Danish fender
Posted: Wed Aug 25, 2010 6:01 pm
by Neil the Don
Oh never mind.
Re: Danish E Bay. NOS H1 Rear "Fender"
Posted: Wed Aug 25, 2010 7:42 pm
by Crispy
Neil the Don wrote: Looks just like the one`s I have had made that ........... Have to put my prices up !!!
You can supply a repro ???
Posted: Wed Aug 25, 2010 8:23 pm
by Crispy
£695!!! somebodies got too much money!
Re: Danish E Bay. NOS H1 Rear "Fender"
Posted: Wed Aug 25, 2010 9:13 pm
by Latch
Neil the Don wrote:Jeez. Have you seen this one ? Bloke in Denmark selling off some NOS stuff. 2 days left and currently at £451. Strangely , I can`t see that its drilled at all. Looks just like the one`s I have had made that ........... Have to put my prices up !!!
£695
Posted: Thu Aug 26, 2010 9:21 am
by Neil the Don
Maybe.......!!
You need to be able to drill holes for mounting , and capable of spacing it out a few mm`s. at the front to get angle right so it follows the wheel line properly. The originals have oval mounting holes, so it would seem , there was a need for minor adjustments from the Factory. You need to supply your own rear mount. Thats the U clamp and rubber. AND there are more than two lengths of them. Another reason to let you drill your own holes.
This is beyond several people , as most folk are used to just bolting on Jap parts. Hence, the "vetting" before I`d sell you one !! ( Otherwise , I risk folk saying they`re rubbish , and don`t fit. Which is less than half the story.!! )
Mind you. There are a few folk had them , and fitted them fine. ( I won`t say who , as they may be passing them of as OEM . Lol )
Posted: Thu Aug 26, 2010 9:26 am
by Neil the Don
£ 695 ??!!!
Hells Teeth. I`d fly to Denmark and fit one of mine on his bike for that price. And then polish the whole bike too !!!!
Oh, before you ask - £125 ea. Extortionate , I know.
Do rear grab rails too y`know. H2B/C and H1D/E/F. 0.5mm thinner O.D. than OEM. There are even more people out there using them. Some VERY well known people. Lol. £75 plus p+p.
Hey, is it ok to advertise on here ? Oh, it must, Simon T.P. does it all the time. ( Cases , Si ? )