Hi all, quuck hello to everyone on here, not been on here for a couple of years due to the usual culprit of losing motivation and selling most of my stuff!
But after watching Allan Millyard and his new s1/s3 550 build it inspired me to drag my engine out over xmas to get the black plastic paint off the crankcases, I have managed to get most of it off the top half and I have a quick question?
As you can see from the photo there is a bit of pitting were the crank fits, no marks on the crank tho, so is this case still usable?
Also attached a few pics of my candy spraying atempts, by no means perfect but not bad especially in the sunlight, shame I got rid off them apart from my z1000 front mudguard which is shown next to the tail piece for comparison and yes it was candy.
So hopefully I can progress on my engine and I still have a kh400 frame that i need to clean and paint and some front forks. The frame in the pics was sold with the other bits just hope it eventually got built.
New returning member.
-
CJWChris
- Newbie
- Posts: 35
- Joined: Wed Aug 20, 2014 10:05 pm
- Location: Wirral
New returning member.
You do not have the required permissions to view the files attached to this post.
-
Wessiedave
- Expert
- Posts: 1182
- Joined: Wed Sep 17, 2008 9:54 am
- Location: Mirfield
Re: New returning member.
Looks good enough to me but you could do with a regular engine builder to give expert advice. If no joy on here try the Facebook group
-
malc87
- Expert
- Posts: 13336
- Joined: Wed May 03, 2006 8:05 pm
- Location: Timperley,South Manchester
Re: New returning member.
What did you use to get the paint off?
-
Craig T
- Expert
- Posts: 524
- Joined: Mon Nov 06, 2006 11:33 am
- Location: Somerset