alloy/coversion

[Degga64]

Stubbled on a link from oz hammer regarding his attempts to convert to alloys.....Any further news as to his success with z250 wheels would be appreciated ..OR anyone got a set of ARE'S begging....degga

[Degga64]

] CONVERSION

[Green Meanie]

I'm in the middle of doing a conversion using GPZ305 wheels, the rear fits straight on same axle diameter, drum brake and the sprocket lines up, just needs a spacer making, front is a bit more difficult, changed bearings so axle will fit , its just finding a disc or discs that will fit, thinking of modifying KH250 discs to fit but its a big job, have to remove the carrier rivets then drill to the GPZ stud pattern, it looks like it could be possible and GPZ305 wheels are dirt cheap.

[Degga64]

good to know it might be possible.....keep me updated with your progress .......

[Twistgrip]

Hi.
There is a KH250 on Gumtree at the moment with GPZ305 wheels in it. Pictures are not very good but it might give you a few ideas. It appears that they have used a complete GPZ front end. Hope this helps.

Regards Alan.